Removing The Expansion Card Risers - Dell EMC PowerEdge GPH2C Installation And Service Manual

Table 20. Configuration 2: R1+R2c (continued)
Card type
Marvell (OCP: 10 Gb)
Intel (OCP: 10 Gb)
Broadcom (OCP: 1 Gb)
Intel (OCP: 1 Gb)
Dell External PERC Adapter
Dell BOSS S1 Module
Intel (PCIe SSD AIC)
Samsung (PCIe SSD AIC)
Table 21. Configuration 3: No Riser
Card type
Broadcom (OCP: 25 Gb)
Intel (OCP: 25 Gb)
Marvell (OCP: 25 Gb)
Mellanox (OCP: 25 Gb)
SolarFlare (OCP: 25 Gb)
Broadcom (OCP: 10 Gb)
Intel (OCP: 10 Gb)
Marvell (OCP: 10 Gb)
Broadcom (OCP: 1 Gb)
Intel (OCP: 1 Gb)
Dell BOSS S1 Module

Removing the expansion card risers

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
Steps
1. For Riser 1, hold the blue touch points, and lift the expansion card riser from the riser connector on the system board.
66 Installing and removing system components
Slot priority
Integrated slot
Integrated slot
Integrated slot
Integrated slot
3, 1
Integrated slot
3, 1
3, 1
Slot priority
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Safety instructions.
Before working inside your
Maximum number of cards
1
1
1
1
2
1
2
2
Maximum number of cards
1
1
1
1
1
1
1
1
1
1
1
system.