Directive; Safety - ESAB Origo A32 Instruction Manual

GB
1

DIRECTIVE

ESAB AB, Welding Equipment, SE--695 81 Laxå, Sweden, gives its unreserved guarantee that weld-
ing power source Arc 150i / Arc 200i from serial number 620 complies with standard IEC/EN
60974--1, in accordance with the requirements of directive (73/23/EEC) and addendum (93/68/EEC)
and with standard IEC/EN 60974--10 in accordance with the requirements of directive (89/336/EEC)
and addendum (93/68/EEC).
--------------------------------------------------------------------------------------------------------------------------------------
Laxå 2006--05--22
Kent Eimbrodt
Global Director Equipment and Automation
ESAB AB
695 81 LAXÅ
SWEDEN
2

SAFETY

Users of ESAB welding equipment have the ultimate responsibility for ensuring that anyone who works on or near the equipment
observes all the relevant safety precautions. Safety precautions must meet the requirements that apply to this type of welding
equipment. The following recommendations should be observed in addition to the standard regulations that apply to the work-
place.
All work must be carried out by trained personnel well- -acquainted with the operation of the welding equipment. Incorrect oper-
ation of the equipment may lead to hazardous situations which can result in injury to the operator and damage to the equipment.
1. Anyone who uses the welding equipment must be familiar with:
its operation
S
location of emergency stops
S
its function
S
relevant safety precautions
S
welding
S
2. The operator must ensure that:
no unauthorized person is stationed within the working area of the equipment when it is started up.
S
no- -one is unprotected when the arc is struck
S
3. The workplace must:
be suitable for the purpose
S
be free from drafts
S
4. Personal safety equipment
Always wear recommended personal safety equipment, such as safety glasses, flame- -proof clothing, safety gloves.
S
Do not wear loose- -fitting items, such as scarves, bracelets, rings, etc., which could become trapped or cause burns.
S
5. General precautions
Make sure the return cable is connected securely.
S
Work on high voltage equipment may only be carried out by a qualified electrician.
S
Appropriate fire extinquishing equipment must be clearly marked and close at hand.
S
bh25d2e
DECLARATION OF CONFORMITY
Tel: + 46 584 81000
- - 13 - -
Fax: + 46 584 411924