Function Test Before Use - Zeiss S100 / OPMI pico Instructions For Use Manual

S100 / OPMI pico

Function test before use

NOTE
NOTE
Version 9.0
G-30-1781-en
Function failure recognized too late!
• To avoid the occurrence of any defects during surgery, perform a system
test before every surgical procedure (without patient)!
Impairment of proper functioning due to malfunction!
For safety reasons, do not use this device if a function fails.
• Rectify the cause of the failure (see "What to do in the event of
malfunctions") or contact ZEISS Service or the authorized partner.
Function test of the surgical microscope
• Before every use, check that all components and accessories which have
been installed are securely locked in place. Note the maximum working
load.
• Check unobstructed movement of the surgical microscope:
 All cables and accessories have been installed in such a way that the
surgical microscope can be safely positioned without causing any
damage.
• Checking eyepieces / binocular tube / objective lens:
 Check that the surgical microscope and the tube are in a position
convenient for you.
 The interocular distance (pupillary distance) has been correctly set
(please refer to Page 104).
 The eyecups have been adjusted to ensure that you can see the full
field of view (see Page 104).
 Verify that the correct prescription has been set on the diopter scale
(please refer to Page 104).
 Check that image quality is correct throughout the entire
magnification range.
 The objective lens and eyepieces are clean.
• Check the function of the magnification changer.
• Check the function of the filter selector knob.
Operation
Page 129