Table of Contents
Advertisement
S
S
UPER
ERVER 6027R-TDARF User's Manual
Ethernet Ports
Two Ethernet ports (LAN1/LAN2) are
located next to the VGA port on the I/O
back panel. An IPMI Dedicated LAN port
is also located above the USB0/1 ports.
This provides a dedicated network con-
nection for IPMI 2.0 support. These ports
accept RJ45 type connectors/cables.
Unit Identifi er Switch/UID LED
Indicators
A Unit Identifi er (UID) switch and two
LED indicators are provided on the
serverboard. The UID switch is located
next to the VGA port on the backplane.
The rear UID LED (LED3) is located next
to the UID switch. The Control Panel
UID LED is located on pins 7/8 of JF1.
Connect a cable to pin 8 on JF1 for the
UID LED on the control panel. When you
press the UID switch, both the rear front
Panel UID LED indicators will turn on.
Press the UID switch again to turn off
both LED indicators. These UID indicators
provide easy identifi cation of a system
unit that may be in need of service.
Note: UID can also be triggered via IPMI
on the serverboard. For more information
on IPMI, please refer to the IPMI User's
Guide posted on our website @http://
www.supermicro.com.
Chassis Intrusion
A Chassis Intrusion header is located at
JL1 on the serverboard. Attach the ap-
propriate cable from the chassis to inform
you of a chassis intrusion when the chas-
sis is opened.
LAN Port
Pin Defi nitions
Pin# Defi nition
1
GND
2
Vcc19-LAN
3
TD3+
4
TD3-
5
TD2+-
6
TD2-
7
TD1+-
8
TD1-
UID Switch
Pin#
Defi nition
1
Ground
2
Ground
3
Button In
4
Ground
UID LED (LED3)
Color/State Status
Blue: On
Chassis Intrusion
Pin Defi nitions
Pin#
1
2
5-16
9
TD0+
10
TD0
11
Link 100 LED
12
Link 100 LED
13
3.3V
14
Act LED
15
GND
16
GND
Status
Unit Identifi ed
Defi nition
Intrusion Input
Ground
Advertisement
Table of Contents
