Installing The Backguard - Bertazzoni PRO36 6 DFS X Installation, Use & Care Manual

INSTALLING THE BACKGUARD
The back guard must be installed prior to
operation of the appliance for appropriate
ventilation of the oven compartment.
The supplied back guard is a 2‐part assembly. The
box also contains a set of metal screws for
securing the back guard to the worktop.
Disassemble the back guard and position the
front part on the worktop. Align the screw holes
with the corresponding holes at the back of the
worktop.
If the holes are not aligned, partially loosen the
brackets at the back of the worktop as shown
below.
Install the front part of the back guard by
tightening the 2 central screws from the top and
2 lateral screws from the bottom.
11