Maintaining Your Range; Cleaning Your Range - Bertazzoni PRO36 6 DFS X Installation, Use & Care Manual

36" freestanding dual fuel ranges
Hide thumbs Also See for PRO36 6 DFS X:
Table of Contents

Advertisement

MAINTAINING YOUR RANGE 
REPLACING THE OVEN LIGHT BULBS 
WARNING! 
Disconnect power before servicing unit. 
To  replace  the  oven  light  bulb,  unscrew  the 
protection cap that projects out inside the oven.  
NOTE: Touching the bulb with fingers may cause 
the bulb to burn out. Always use protective glove 
or use a cloth to remove the bulb. 
CLEANING YOUR RANGE 
ATTENTION! 
Never use abrasive cleaners!  
Scratches on the stainless steel surfaces are 
permanent. 
Do not clean the range when hot! 
Cleaning  after  installation:  use  a  stainless  steel 
cleaning  product  or  wipe  to  eliminate  the  glue 
residues  of  the  blue  protection  film  after 
removal. 
Cleaning  the  worktop:  periodically  clean  the 
burner heads, the cast iron pan supports and the 
burner  caps  using  warm  water.  Remove  burned 
food  and  fat  residues  with  a  rubber  spatula  .  If 
 
 
 
 
 
 
food  residue  prevent  the  smooth  operation  of 
the  control  knobs,  call  the  customer  service 
hotline  to  schedule  service  by  a  factory‐trained 
professional. 
Cleaning  stainless  steel:  for  best  results  use  a 
stainless steel cleaner product with a soft sponge 
or  wipe.  Alternatively  use  a  soft  sponge  or  cloth 
with a warm soap and water solution. Never use 
abrasive powders or liquids!  
Cleaning  the  burner  caps:  lift  the  burner  caps 
from the burner heads and wash them in a warm 
soap  and  water  solution.  Dry  thoroughly  before 
using them again. Before reinstalling them on the 
burner  head,  check  that  the  gas  flow  holes  are 
not  clogged  with  food  residues  or  cleaning 
product residues. 
Cleaning  Enamel:  enamelled  parts  should  be 
cleaned  frequently  with  warm  soap  and  water 
solution  applied  with  a  soft  sponge  or  wipe. 
Never  use  abrasive  powders  or  liquids!  Do  not 
leave  acid  or  alkaline  substances  on  the 
enamelled  parts  (such  as  vinegar,  lemon  juice, 
salt, tomato sauce, etc.). Use a rubber spatula to 
remove fat residues. 
Cleaning glass door: clean the glass using a non‐
abrasive  sponge  or  wipe  with  a  warm  soap  and 
warm  water  solution.  Use  a  rubber  spatula  to 
remove fat residues.  
ATTENTION:  while  cleaning  the  door,  avoid 
spillage of food residues and cleaning products in 
the venting holes situated on the top side of the 
door. To clean the inside of the oven door, call a 
factory‐trained professional.  
ATTENTION: for further details about cleaning of 
the  appliance,  please  contact  your  appliance 
retailer. 
 
 
 
 
 
 
 
 
 
 
37

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pro36 6 dfs arPro36 6 dfs biPro36 6 dfs nePro36 6 dfs roPro36 6 dfs viPro36 6 dfs gi ... Show all

Table of Contents