Weighing A Sample - Adam AGB35 Manual


Zero the scale by pressing the [0/Esc] key if necessary. The "ZERO"
indicator will be ON. 0

Place a container on the platform; a value for its weight will be displayed.

Press the [Tare/↵] key to tare the scale. The weight that was displayed is
stored as the tare value and that value is subtracted from the display, leaving
zero on the display. The "NET indicator will be ON. As a product is added
only the net weight of the product will be shown. The scale could be tared a
second time if another type of product was to be added to the first one. Again
only the weight that is added after taring will be displayed.

When the container is removed a negative value will be shown. If the scale
was tared just before removing the container this value is the gross weight of
the container plus all products that was removed. The "ZERO" indicator will
be on to indicate that the platform is back to the same condition as it was
when zero was last set.

To delete a Tare value, press [0/Esc] when the pan is empty.
6.3

WEIGHING A SAMPLE

To determine the weight of a sample, first tare the empty container if it is to be used and
then place the sample in the container. The display will show the net weight of the sample
and the units of weight currently in use.