JLG 1850SJ Operation & Safety Manual page 78

Hide thumbs Also See for 1850SJ:

Table of Contents

Machine Operation

To avoid tip over, if red tilt warning light illuminates when the boom is raised

above horizontal, lower platform to ground level. Then reposition machine so that

chassis is level before raising boom.

If the platform does not stop when a control switch or lever is released, remove

foot from footswitch or use emergency stop switch to stop the machine.

Traveling with the boom below horizontal is permitted on grades and side slopes

specified in the Operating Specifications section of this manual.

To avoid serious injury, do not operate machine if any control lever or toggle switch

controlling platform movement does not return to the off or neutral position when

released.

To avoid a collision and injury if platform does not stop when a control switch or

lever is released, remove foot from footswitch or use emergency stop switch to

stop the machine.

4.14.1

Swinging the Boom

Note: The axles must be fully extended to swing beyond the rear wheels (40 degrees).

To swing boom, use Swing control switch to select Right or Left direction.

When swinging the boom make sure there is ample room for the boom to clear

surrounding walls, partitions and equipment.

WARNING

CAUTION

NOTICE

31222393

1850SJ

Table of Contents