JLG 1850SJ Operation & Safety Manual page 68

Machine Operation
If engine fails to start promptly, do not crank for an extended time. Should engine
fail to start again, allow starter to cool off for 2-3 minutes. If engine fails after
several attempts, refer to engine maintenance manual.
Note: Diesel engines only: After turning on ignition power, operator must
wait until glow plug indicator light goes out before cranking engine.
1.
Turn key of Platform/Ground Select switch to Ground.
2.
Pull the Power/Emergency Stop switch to On.
3.
Push the Engine Start switch until engine starts.
Allow engine to warm-up for a few minutes at low speed before applying any load.
4.
After engine has had sufficient time to warm up, push in the Power/
Emergency Stop switch and shut engine off.
5.
Turn Platform/Ground Select switch to Platform.
6.
From Ground Control Console, pull Power/ Emergency Stop switch out.
68
CAUTION
CAUTION
31222393 1850SJ