Server Chassis Features - Supero SuperServer 7044A-82R User Manual

Other Features
Other onboard features that promote system health include onboard voltage
monitors, a chassis intrusion header, auto-switching voltage regulators, chassis
and CPU overheat sensors, virus protection and BIOS rescue.
1-3

Server Chassis Features

The SuperServer 7044A-82R is a high-end, scaleable server platform designed
with today's most state-of-the-art features. The following is a general outline of
the main features of the SC942i-R760 server chassis.
System Power
The 7044A-82R features a triple redundant 760W power supply that consists of
three separate power supply modules. These modules all share the load and run
continuously. If any of the three fail, the remaining two pick up the load and keep
the system running without interruption. A failed power supply module will
illuminate the power fail LED. The power supply modules are all hot-swappable,
so you don't have to power down the system to replace a module.
SCSI Subsystem
The SCSI subsystem supports up to five* 80-pin SCA Ultra320 SCSI hard drives.
(Five SCSI trays have been designed to fit into a mobile rack that is housed in
the chassis. Any standard 1" drives are supported. SCA = Single Connection
Attachment.) The SCSI drives are connected to a dual-channel SCA backplane
with SAF-TE. The SCSI drives are also hot-swap units. A RAID controller card
can be used with the SCA backplanes to provide data security.
* The system can support up to 10 hot-swappable Ultra320 SCSI drives if another
mobile rack (CSE-M35S) is installed.
Note: The operating system you use must have RAID support to enable the hot-
swap capability of the SCSI drives.
1-3
Chapter 1: Introduction