Static Route Overview; Configuring Static Route; Figure 79 Example Of Static Routing Topology; Figure 80 Configuration > Network > Static Route - ZyXEL Communications IP PBX X6004 User Manual

Chapter 6 Network Deployment
Table 15 Configuration > Network > NTP
LABEL
End Date
Offset
Apply
Reset

6.6 Static Route Overview

In a subnetted LAN environment the X6004 is typically connected to a router. The router
specifies the subnet to which the X6004 is directly connected and the X6004 has no
knowledge of the subnets beyond. For instance, the X6004 knows about the IP phones in
subnet N1 in the following figure. However, the X6004 is unable to route a packet to phones in
subnet N2 because it doesn't know that there is a route through Router 1 (R). Static routes tell
the X6004 about the subnets beyond the router its directly connected to.

Figure 79 Example of Static Routing Topology

6.6.1 Configuring Static Route

Use this screen to look at static routes in the X6004. Click Configuration > Network > Static
Route to open the Static Route screen.
Figure 80 Configuration > Network > Static Route
90
DESCRIPTION
Enter which hour on which day of which week of which month daylight-savings
time ends.
Enter the amount of time (in hours) by which to adjust the time during daylight
saving period.
Click this to save your changes.
Click this to set every field in this screen to its last-saved value.
Internet
X6004 User's Guide