Table of Contents
Advertisement
Figure 217 Maintenance > Administration > Diagnostic > Packet Capture
Each field is described in the following table.
Table 119 Maintenance > Administration > Diagnostic > Packet Capture
LABEL
Machine ID
Interface
Host
Protocol
Stop capture after
.. Packets
Stop capture after
.. Sec.
X6004 User's Guide
DESCRIPTION
If you have more than one X6004 configured in a ZyStack, select the one from
which you want to collect information.
Choose the interface for which you want to log network traffic.
Optionally, limit the capture of information to communication with a specific
network device. Enter the IP address of the network device that the X6004 is
communicating with. You can also enter the IP address of the X6004 itself, in
which case, the X6004 only collects information where the destination or source IP
matches that of the X6004.
Specify the protocol type which you want to capture information on. You can
choose TCP, UDP, ICMP or select All to capture all IP traffic going through the
X6004.
Specify how many packets you want to collect before ending the packet capture. If
you select to limit the capture by the number of packets and by total time of the
capture, then the capture session will end when the time limit is reached.
Note: You must specify either a time limit or a total number of
packets limit for the data capture.
Specify how long a packet capture session should last. If you select to limit the
capture by the number of packets and by total time of the capture, then the
capture session will end when the time limit is reached.
If you do not specify any limits for the capture, then the capture will last for the
maximum time allowed (600 seconds).
Note: You must specify either a time limit or a total number of
packets limit for the data capture.
Chapter 29 Diagnostics
251
Advertisement
Table of Contents
