Using A Different Configuration File; Resetting To The Factory Default; Figure 168 Cli: Restore Configuration Example; Figure 169 Cli: Boot Config Command Example - ZyXEL Communications ZyXEL Dimension GS-4012F User Manual

GS-4012F/4024 User's Guide
This command restores a configuration file on the switch. The following example uploads the
configuration file (

Figure 168 CLI: Restore Configuration Example

ras# copy tftp config 1 172.23.19.96 test.cfg
Restoring
. (683)Bytes Done!
ras#

41.6.3 Using a Different Configuration File

You can store up to two configuration files on the switch. Only one configuration file is used at
a time. By default the switch uses the first configuration file (with an index number of 1). You
can set the switch to use a different configuration file. There are two ways in which you can set
the switch to use a different configuration file: restart the switch (cold reboot) and restart the
system (warm reboot).
Use the
boot config
specified). The following example restarts the switch to use the second configuration file.

Figure 169 CLI: boot config Command Example

ras# boot config 2
Use the
reload config
(if specified). The following example restarts the system to use the second configuration file.

Figure 170 CLI: reload config Command Example

ras# reload config 2
Note: When you use the
file index number, the switch saves the changes to the configuration file the
switch is currently using.

41.6.4 Resetting to the Factory Default

Follow the steps below to reset the switch back to the factory defaults.
1 Enter
erase running config
2 Enter
write memory
reset the second configuration file, use the
specified index number.
274
) from the TFTP server (
test.cfg
command to restart the switch and use a different configuration file (if
command to restart the system and use a different configuration file
write memory
to reset the current running configuration.
to save the changes to the current configuration file. If you want to
172.23.19.96
command without specifying a configuration
command again with the
write memory
Chapter 41 Command Examples
) to the switch.