ZyXEL Communications ZyXEL Dimension GS-4012F User Manual page 124

Table 34 Classifier (continued)
LABEL
Layer 2
Specify the fields below to configure a layer-2 classifier.
VLAN
Priority
Ethernet Type Select an Ethernet type or select Other and enter the Ethernet type number in
Source
MAC Address
Port
Destination
MAC Address
Layer 3
Specify the fields below to configure a layer 3 classifier.
DSCP
IP Protocol
Source
IP Address/
Address Prefix
Socket
Number
Destination
IP Address/
Address Prefix
Socket
Number
Add
Chapter 18 Classifier
DESCRIPTION
Select Any to classify traffic from any VLAN or select the second option and specify
the source VLAN ID in the field provided.
Select Any to classify traffic from any priority level or select MAC and specify a priority
level in the field provided.
hexadecimal value. Refer to
Select All if you don't know.
Select Any to apply the rule to all MAC addresses.
To specify a source, select MAC and type a MAC address in valid MAC address format
(six hexadecimal character pairs).
Select the port to which the rule should be applied. You may choose one port only or all
ports (All Ports).
Select Any to apply the rule to all MAC addresses.
To specify a destination, select the second choice and type a MAC address in valid
MAC address format (six hexadecimal character pairs).
Select Any to classify traffic from any DSCP or select the second option and specify a
DSCP (DiffServ Code Point) number between 0 and 63 in the field provided.
Select an IP protocol type or select Other and enter the protocol number in decimal
value. Refer to Table 37 on page 125
You may select Establish Only for TCP protocol type. This means that the switch will
pick out the packets that are sent to establish TCP connections.
Enter a source IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
Note: You must select either UDP or TCP in the IP Protocol field
before you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the
second option and enter a TCP/UDP protocol port number.
Enter a destination IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
Note: You must select either UDP or TCP in the IP Protocol field
before you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the
second option and enter a TCP/UDP protocol port number.
Click Add to save the changes.
GS-4012F/4024 User's Guide
Table 36 on page 124 for information.
for more information.
123