Configuring The Switch Using The Cli - ZyXEL Communications VES-1616 Support Notes

ZyXEL VES-1616/24FA-5x Series Support Notes
13. PING PC C from PC A (not successful with request timed out message)

Configuring the Switch Using the CLI

1. Connect the your computer to the console port on the switch
2. Open your Terminal program (for example, Hyper Terminal in Windows
System).
3. Make sure the console connection settings are configured as listed below.
Bps: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None:
4. After you can connect successfully, enter the user name and password.
5. Enter "config" to go into the configuration mode.
6. Enter the following commands to configure Port Based VLAN on your Switch in
this network example.
All contents copyright 2008 ZyXEL Communications Corporation. 32