ZyXEL Communications VES-1616 Support Notes page 77

ZyXEL VES-1616/24FA-5x Series Support Notes
VES-1616FA-54(config-vlan)# fixed 1
Step 4: On the VES-1616FA-54, in the configure mode, create VLAN 40, and
set the port 2 to be fixed port.
VES-1616FA-54(config)# vlan 40
VES-1616FA-54(config-vlan)# untagged 2
VES-1616FA-54(config-vlan)# fixed 2
Step 5: On the VES-1616FA-54, in the configure mode, create VLAN 50, and
set the port 3 to be fixed port.
VES-1616FA-54(config)# vlan 50
VES-1616FA-54(config-vlan)# untagged 3
VES-1616FA-54(config-vlan)# fixed 3
Step 6: On the VES-1616FA-54, set the PVID of specific VLAN 30
VES-1616FA-54(config)# interface port-channel 1
VES-1616FA-54(config-interface)# pvid 30
VES-1616FA-54(config-interface)# exit
Step 7: On the VES-1616FA-54, set the PVID of specific VLAN 40
VES-1616FA-54(config)# interface port-channel 2
VES-1616FA-54(config-interface)# pvid 40
VES-1616FA-54(config-interface)# exit
Step 8: On the VES-1616FA-54, set the PVID of specific VLAN 50
VES-1616FA-54(config)# interface port-channel 3
VES-1616FA-54(config-interface)# pvid 50
VES-1616FA-54(config-interface)# exit
Step 9: On the VES-1616FA-54, in the configure mode, enable IGMP
snooping
VES-1616FA-54(config)#igmpsnooping
Step 10: On the VES-1616F-3X, in the configure mode, create MVR
VES-1616FA-54(config)# mvr 100
Step 11: Define the Dynamic mode
VES-1616FA-54(config-mvr)# mode dynamic
Step 12: on the VES-1616FA-54, in the MVR 100, set up the multicast group
address.
VES-1616FA-54(config-mvr)# group test start-address 233.1.1.1
end-address 233.1.1.100
Step 13: In the MVR 100, specify receiver ports on port 1~3 as untagged
ports
VES-1616FA-54(config-mvr)# receiver-port 1-3
VES-1616FA-54(config-mvr)# untagged 1-3
Step 14: Then, specify the source port 17 and assign it to be tagged ports
VES-1616FA-54(config-mvr)# source-port 17
VES-1616FA-54(config-mvr)# tagged 17
All contents copyright 2008 ZyXEL Communications Corporation. 76