Rope Guiding Device (Optional) - HADEF 46/21E Installation, Operating And Maintenance Instruction

12.7.2 Setting for wire rope exit exceeding 45°
Further setting is necessary if the wire rope
exit exceeds 45°
 Release the screw (1) slightly
 Turn the square (2) until the roller puts
pressure on the wire rope.
 Hold the square (2) and tighten the screw (1)
again.
12.8

Rope guiding device (Optional)

1 Universal spindle
2 Sliding block receiver
3 Sliding block
4 Guiding roller
5 Roller chain
6 Tensioning wheel
7 Chain wheel
a
12.8.1 Dismantling - Sliding block
1 Universal spindle
2 Sliding block receiver
3 Sliding block
4 Laying block
5 Screws
For dismantling the sliding block (3) move the
laying block (4) centered to the universal spindle
(1).
WARNING!
Before starting dismatling, remember the position of the sliding block respective to the direction of the
grooves!
 Loosen the screws (5)
 Take out the sliding block receiver (2) to the
upper side.
 Take out the sliding block (3) to the front side.
12.8.2 Assembly - sliding block
Assembly of the sliding block (3) is carried out in reverse order.
WARNING!
It is important the assemble the sliding block at the same position as it was disassembled before!
22
Illustration 27
Illustration 28
Illustration 29
Illustration 30
5.52.262.00.01.13