Maintenance - 250H; Checking - Cleaning - Dynapac CC1200 Instruction Manual

Fig. Engine compartment
1. Water cooler
2. Hydraulic fluid cooler
2011-03-21

Maintenance - 250h

Coolers

Checking - Cleaning

Make sure that the air flow through the coolers (1) and
(2) is unobstructed. Dirty coolers are blown clean with
compressed air or washed clean using a
high-pressure water cleaner.
1
Blow air or direct water through the cooler in the
opposite direction to that of the cooling air.
2
ICC1200-1EN2.pdf
Maintenance - 250h
Park the roller on a level surface. Park the roller on a level surface.
The engine must be switched off and the The engine must be switched off and the
parking brake activated when checking or parking brake activated when checking or
adjusting the roller, unless otherwise specified. adjusting the roller, unless otherwise specified.
Ensue that there is good ventilation (air Ensue that there is good ventilation (air
extraction) if the engine is run indoors. Risk of extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning. carbon monoxide poisoning.
Take care when using a high-pressure water jet. Take care when using a high-pressure water jet.
Do not hold the nozzle too near the cooler. Do not hold the nozzle too near the cooler.
Wear protective goggles when working with Wear protective goggles when working with
compressed air or high-pressure water jets. compressed air or high-pressure water jets.
75