Maintenance - Wolf Garten Power Edition 46 HA Instruction Manual

Hide thumbs Also See for Power Edition 46 HA:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 25
Operation
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf. Do not se cutting position too low when mowing very hight or wet grass. We
recommend an average cutting height of 4,5 cm.
Cold start - Power Edition 40 H 40 (fig. B5/B6/B8)
Place mower on level ground, not onto high grass. Open petrol valve. Petrol cock B5 (A) in position B5 (b). Accelerator lever B6 (1) in
START position. Lift and hold safety bar B6 (2). Pull starter cord B8 (4) rapidly and return starter grip slowly. After engine started to run,
move throttle lever to „Betrieb". To stop engine: Release safety bar B6 (2). Starting or warm engine: Throttle lever B6 (1) to „Betrieb „ (=
running). If engine will not start after secónd attemp, place throttle to „Start" position and try again.
Cold start - Power Edition 46 HA 40 46 HA 40 (fig. B5/B7/B8)
Place mower on level ground, not onto high grass. Open petrol valve. Petrol cock B5 (A) in position B5 (b). Accelerator lever
B7 (1) in START position. Lift and hold safety bar B7 (3). Pull starter cord B8 (4) rapidly and return starter grip slowly. After engine
started to run, move throttle lever to „Betrieb". To engage drive: Lift driving bar B7 (5) Drive OFF: Release driving bar B7 (5). Set
speed: 1st gear B7 (6) = slow (2 km/h). 2nd gear B7 (7) = fast (4 km/h). To stop engine: Release driving bar B7 (5). Release safety
bar B7 (3). Starting or warm engine: Throttle lever B7 (1) to „Betrieb „ (= running). If engine will not start after secónd attemp, place
throttle to „Start" position and try again.
Mowing (fig. B9)
Always mow using throttle lever setting OECO or Power. Mow with throttle lever on "Betrieb" position. Start engine with mower placed on
level and firm ground. Turn Mower on lawn area already mown. Do not leave mower standing with engine running for longer than absolutely
necessary.
Emptying of grassbox (fig. B10)
Only when mower is stionary and rotating blade has come to complete standstill.
Box filling indicator: The flap drops down when grassbox is full. To ensure properfunctioning of the indicator it is important that the grilles
below are kept clean using a hand brush.

Maintenance

Disconnect spark plug cap and starter key (with electric-start-models) before proceeding!
Clean mower thoroughly after each mowing with cloth or brush.
Do not spray with water. Keep mower in a dry room.
Change oil only
While engine is warm and fuel tank empty.
Change oil after 5 working hours for the first time. After every 25 working hours from then onwards and at the end of the mowing season.
More frequently if working under extreme and dusty conditions. Remove oil filling cap, tilt machine slowly to side and allow oil to drain from
the crankcase.
Cleaning of Spark Plug
Check and clean and regulary, as required (Briggs & Stratton 0,76 mm).
Cleaning of air filter
See the operating instructions of the motor manufacturer (enclosed).
Cleaning operations and blade change (fig. W1)
Tilt the mower towards rear for cleaning operations and blade change: Detach spark plug cable. Fold upper part of handle forwards (avoid
damage to Bowden cables).
Sharpening and changing blade (fig. W2)
Blade should always be sharpened by an approved Service Centre. Change blade according to drawing.
Gloves should be worn at all times when working on the blade. Remove ignition key and spark plug lead when working on the
blade.
Information for Service Centre, blade retaining screw to be tightened to: screw = 38-42 Nm, A/F 17 mm.
Winter storage
• Drain fuel tank.
• Drain carburettor
- therefore start engine, keep it runninug until it automaticalli switches off.
• Clean the whole machine thoroughly
• Change oil, 4-stroke engine.
• Prepare engine for winter storage as follows:
- Remove spark plug. Poor one spoon full of engine oil into spark plug hole. Pull starter rope slowly to distribute oil evenly inside cylinder.
- Replace spark plug but do not connect spark plug lead.
- Pull starter rope until resistance is felt (valves are now closed)
• Store mower in a cool and dry place.
We recommend: Have your mower thoroughly checked once a year by approved Service Agent.
28

Advertisement

Table of Contents
loading

This manual is also suitable for:

Power edition 40 h

Table of Contents