Maintenance; Faults And How To Remedy; Technical Data - Wolf Garten Premio 40 E Instruction Manual

Maintenance

Cleaning
Note: Disconnect electricity by unplugging cable at the socket before proceeding. Attention: Keep hands clear of moving blade.
Clean mower thoroughly after each mowing with cloth or brush.
Do not spray with water. Keep mower in a dry room.
Change of cutter blade (fig. W1)
Note: Always disconnect mains supply and wear protective gloves before undertaking any work at the cutter blades, cutter
bar and blade coupling.
Change cutter blade using 13 mm spanner as illustraded. Torque wrench setting for screws 22-24 Nm. Take care to carry out this
work thoroughly. Use original spare parts only.
Note: Sharpining of blades should be done by an approved service centre as the correct balance of the blade after sharpening
is very important and ought to be checked by an expert.
Winter Storage:
Clean mower thoroughly before storing away.
Never spray mower with water and do not store it in a wet or humid place.
Have yourmower thoroughly checked once a yearby an approved Service Centre. We reserve the right to change any technial
specifications at our discretion.
Adjusting the clutch Bowden cable - Premio 40 EA/46 EA (fig. W2)
Lift the drive bar (1) approx. 2 cm and hold. Loosen counternut (2) and turn adjusting screw (3) anticlockwise until the drive wheels block when
the mower is pulled backwards. Tighten counternut (2) firmly.

Faults and how to remedy

Technical Data

We reserve the right of technical changes.
12