Oneida Air Systems BenchTop Owner's Manual page 13

assembly Instructions (Continued)
THIS MACHINE MuST HAvE A gROuND pRONg IN THE plug TO HElp ENSuRE THAT IT IS gROuNDED. DO

NOT REMOvE gROuND pRONg FROM plug TO FIT INTO A TWO-pRONgED OuTlET! IF THE plug WIll
NOT FIT THE OuTlET, HAvE THE pROpER OuTlET INSTAllED By A QuAlIFIED ElECTRICIAN.
Plug the female end of the AC Cord (K) into
3
the BenchTop Assembly's (A) male port. Make
certain that the power switch is in the off
position and then plug the AC Cord into an
AC power source (wall outlet) [FIG. 3].
Note: We recommended that you work close
to the front of the unit to ensure the best dust
collection possible. This unit is not meant to
replace other source collection devices, such
as built in dust ports or bags. It is meant to
supplement those tools and create a cleaner zone
of air around the user.
Press the switch to the RESET position [FIG.
4
4a]. The fan speed can be adjusted as needed
using the knob below the switch [FIG. 4b].
Tools can be plugged into the accessory port
5
and should not exceed 10 amps [FIG. 5].
Note: Tools plugged into the accessory port will
remain powered on even when the power switch
is in the OFF position.
OFF
RESET
OFF
FIG. 3
RESET
OFF
FIG. 4a
FIG. 5
oneida-air.com
RESET
OFF
FIG .4b
11