Husqvarna 250 XC TPI 2021 Owner's Manual page 109

–
Push protection cap
E01426-10
–
Unplug connector
–
Remove thermostat
escapes without bubbles.
–
Mount thermostat
Guideline
Screw, cylinder head
temperature sensor
–
Plug in connector
E01427-10
–
Position protection cap
–
Pour coolant in up to measurement
Guideline
10 mm (0.39 in)
Coolant (
400243-10
–
Mount radiator cap
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
E01430-10
–
Allow the engine to warm up and cool down again.
–
Check the cooling system for leaks.
Finishing work
–
Check the coolant level. (
3
upward over the thermostat.
4
.
5
with O-ring and wait until the coolant
5
with the O-ring and tighten.
M10x1.25
4
.
3
.
A
above the radiator fins.
p. 138)
2
.
p. 103)
COOLING SYSTEM 15
12 Nm (8.9 lbf ft)
107