Remote Control System - Meridian 4055 SEED EXPRESS Operator's Manual

Operator's Manual: 4055 Seed Express
Each radio remote control handset transmitter is
designed to operate with a unique radio ID code
and RF channel sequence. Each control panel
receiver is programmed to respond only to the
handset transmitter with the correct ID code/
RF channel sequence for which it is set. This
feature allows multiple systems to work in close
proximity to one another without interference.
If the handset goes out of range for more than
two seconds, all outputs except CONVEYOR
will turn off as a safety feature.
In the event that the handset becomes damaged
and a new one is needed, the control panel
receiver can be reprogrammed to respond to the
new control. Refer to Section 4.3.9 (Page 4-11)
All of the normal functions of the seed tender
can be controlled by the remote control handset.
a
c
d
g
h
Fig 18 - Remote control handset transmitter
3-10
Bulk Seed Tender
™

3.4 REMOTE CONTROL SYSTEM

b
e
f
i
®
3.4.1 Functions of Handset Buttons:
Use the buttons on the control to operate the
functions of the seed tender.
a. POWER:
Press Power button (a) to turn ON the
handset. Press and hold the button to turn
it OFF.
To save battery life, the handset will automatically
turn off when it is idle (no functions are used) for
a period greater than the sleep time (default is
15 minutes). Refer to Section 4.3.10 (Page 4-11)
to change the sleep time.
Note:
The remote control handset will NOT
automatically shut off as long as
the control panel receiver has
power applied to it.
b. ENG STOP:
Stop the engine with this button.
c. CONVEYOR - INC/STOP:
These Conveyor buttons start and stop the
conveyor belt.
The conveyor has three speeds:
- Press the INC button once to start the
conveyor at low speed.
- Press the button again for medium speed,
and a third time for high speed.
- The fourth time will return to low speed.
Note: The conveyor will start at the last
speed used once stopped, always return
conveyor belt speed to low before stopping.
®
11.2022