Table of Contents
Advertisement
Operator's Manual: 4055 Seed Express
d. GATE 1 and GATE 2:
The Slide Gate buttons open and close
the slide gates at the bottom of both
compartments.
- Hold either button to fully open or fully
close. Release the button when the desired
amount of product flow is achieved.
e. CONVEYOR - FRONT/REAR:
These Conveyor buttons swing the conveyor
tube.
f.
CONVEYOR - UP/DOWN:
These Conveyor buttons raise and lower the
conveyor tube.
g. TARE:
The Tare button will reset the scale to
zero in order to measure only the content
being added to one compartment without
measuring the weight of the seed tender
itself. This allows an exact measurement of
the seed to be placed in the compartment.
h. ENG START:
Start the engine with this button.
Note: If the engine has not been started
recently set the choke to ON.
11.2022
Bulk Seed Tender
™
®
i.
AUTO RESET:
Pressing the AUTO RESET button on
the handset will dispense the Weight To
Dispense out the selected gate. The gate that
was selected in the Active Gate screen will
open in #s. The unit will monitor the weight
being dispensed. As the weight approaches
the desired Weight To Dispense, the gate will
begin to close. If the weight stops changing
too soon, the unit will open the gate slowly in
order to get the desired amount.
- The auto reset mode does not turn the
- If the remote control is in the middle of auto
- If the remote goes into the sleep mode
- Pressing any of the gate function buttons
- If, during the auto dispense mode, the
conveyor on. The desired speed for the
conveyor should be set manually.
dispense mode and the handset goes out
of range, the unit will close all open gates
regardless the status of dispensing.
during the auto dispense mode, the unit
will abort the auto dispense mode and
close the active gate.
on the handset will close the active gate
and stop the auto dispense mode.
POWER button is pressed, the active gate
will close.
®
3-11
Advertisement
Table of Contents
