Table of Contents
Advertisement
Operator's Manual: 4055 Seed Express
3.3.1 Setting Weight to Dispense:
1. Select the Weight To Dispense screen using
scroll button ( k).
2. Press and hold Tare button ( l ) for five
seconds.
3. The first character of the weight will start
blinking.
4. Use the Increase ( j) or Decrease ( i) buttons
to select the appropriate number.
5. Use the Scroll button to move to the next
digit. Use the Increase ( j) or Decrease ( i )
buttons to select the appropriate number.
Repeat this until the desired weight has
been entered.
6. Finally, holding the Tare button ( l) for another
five seconds to save the new weight.
Note:
The weight of the seed is calculated when it
is inside the compartments and as it flows
through the slide gates. Any seed in the
seed pan or the conveyor has already been
weighed and does not affect the total weight.
3.3.2 Setting Active Slide Gate:
1. Select the Active Slide Gate screen using
scroll button ( k).
2. Use the Increase ( j )/Decrease ( i) buttons to
set either slide gate #1 or #2.
3. When the Auto Reset button is pressed on
the handset, the slide gate selected will
open automatically.
11.2022
Bulk Seed Tender
™
®
3.3.3 Auto Reset Function:
1. Using the Weight To Dispense screen, select
the desired weight of seed to be delivered to
the planter.
2. Using the Active Slide Gate screen, select
either Slide Gate #1 or #2).
3. Press the Auto Reset button on the handset.
The unit monitors the weight of seed being
dispensed. As the weight approaches the
desired Weight To Dispense, the slide gate
will begin to close. If the weight stops
changing too soon, the unit will open the
slide gate slowly in order to get the desired
amount.
3.3.4 Control System Compliance Information:
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference. This
equipment generates radio frequency energy
and if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to the reception of
other electronics, which can be determined
by turning the equipment off and on, DO NOT
operate this equipment around those devices.
This equipment has been certified to comply
with the limits for a Class B computing device,
pursuant to FCC Rules. In order to maintain
compliance with FCC regulations, shielded
cables must be used with this equipment.
Operation with non-approved equipment or
unshielded cables is likely to result in interference
to electronic device reception. The user is
cautioned that changes and modifications made
to the equipment without the approval of the
manufacturer could void.
®
3-9
Advertisement
Table of Contents
