Table of Contents
Advertisement
Operator's Manual: Seed Titan
4.3.15 Trailer Break-Away System:
Testing the Battery:
1. Disconnect the trailer plug from the tow
vehicle; otherwise, you are testing the tow
vehicle's battery.
2. Press the green TEST button on the control
box located inside the frame of the trailer.
- The green indicator light will illuminate if
the battery is fully charged.
- If the yellow or red indicator lights
illuminate, the unit's battery should be
charged before towing the trailer.
IMPORTANT:
If the battery is weak or dead (red indicator,
even after charging), as indicated by the
indicator light, the battery must be replaced.
3. Plug the trailer into the tow vehicle. The
yellow "Charging" light should be ON.
4. Test the system by pulling the pin out of
the break-away switch. The battery will
activate the brakes. (Note: Do not use this
kit as a parking brake). The battery should
be charged and tested prior to each trailer
outing.
Changing Battery:
The battery in the break-away system is
rechargeable. If the battery will not hold a
charge, replace the battery.
Replacing Battery:
The battery in the break-away system is
replaceable. If the battery will not hold a charge,
replace the battery. Contact the OEM supplier
for a replacement battery.
Revised 02.2021
2SE/4SE Box Seed Tender
™
10.9 TRAILER BREAK-AWAY SYSTEM
Fig 85 - Tongue of trailer
Fig 86 - Break-Away system
10.9.1 Testing the Battery
1. Disconnect the trailer plug from the tow
vehicle; otherwise, you are testing the tow
vehicle's battery.
2. Press the green TEST button on the control
box located inside the frame of the trailer. The
green indicator light should illuminate if the
battery is fully charged. If the yellow or red
indicator lights illuminate, the unit's battery
should be charged before towing the trailer.
IMPORTANT
If the battery is weak or dead (red indicator, even
10.9
The
rech
repla
10.9
The
repla
repla
a re
10.1
REQ
4-15
Advertisement
Table of Contents
