Control System Compliance Information; Wireless Remote Control; Functions Of Keypad Buttons - Meridian SEED EXPRESS Series Operator's Manual

5.3.2 Control System Compliance
Information
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference. This
equipment generates radio frequency energy
and if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to the reception of other
electronics, which can be determined by turning
the equipment off and on, DO NOT operate this
equipment around those devices.
Thisequipmenthasbeencertifiedtocomplywith
the limits for a Class B computing device, pursuant
to FCC Rules. In order to maintain compliance
with FCC regulations, shielded cables must be
used with this equipment. Operation with non-
approved equipment or unshielded cables is
likely to result in interference to electronic device
reception. The user is cautioned that changes and
modificationsmadetotheequipmentwithoutthe
approval of the manufacturer could void the user's
authority to operate this equipment.

5.3.3 Wireless Remote Control

Each radio wireless remote control is designed
to operate with a unique radio ID code and RF
channel sequence. Each receiver is programmed
to respond only to the wireless remote control
with the correct ID code/RF channel sequence
for which it is set. This feature allows multiple
systems to work in close proximity to one another
without interference.
If the wireless remote control goes out of range
for more than two seconds, all latched outputs will
turn off as a safety feature.
In the event that a wireless remote control
becomes damaged and a new one is needed,
the receiver can be reprogrammed to respond
to the new wireless remote control. Refer to the
10.1.3 Remote Control Transmitter and Receiver
Synchronization section in the Maintenance
section of this manual.
All of the normal functions of the seed tender can
be controlled by the wireless remote control.
28

5.3.3 Functions of Keypad Buttons

Use the buttons on the keypad to operate the
desired functions of the seed tender.
POWER (1)
PressPowerbutton(1)toturnwirelessremote
control ON. Press and hold the button to turn it
OFF.
To save battery life, the wireless remote control will
automaticallyturnoffwhenitisidle(nofunctions
areused)foraperiodgreaterthan15minutes.
Press the POWER button to turn the unit ON.
NOTE: The wireless remote control will NOT
automatically shut off as long as the receiver has
power applied to it.
ENGINE STOP (2)
Press Engine Stop button to turn OFF engine.
ENGINE START (3)
Press the engine start button to start the engine. If
the engine has not been started recently, set the
choke to ON.