Husqvarna Rider 13C Workshop Manual page 65

Microswitch: Seat
1. Fold up the seat and remove the spring disc
with spring and spacer sleeve. The
microswitch holder is released.
2. Disconnect the cable connections from the
microswitch.
3. Press in the fasteners and remove the
microswitch from the holder.
Assembling is done in the reverse order without
setting.
Microswitch: Mowing Deck
1. Loosen the right-hand wing cover.
2. Remove the inner protecting plate on the gear
lever carrier.
3. Release the connector from the microswitch.
4. Remove the microswitch.
Assembling is done in the reverse order without
setting.
Microswitch: Neutral Position
1. Remove the transmission cover.
2. Check the hydrostatic cable adjustment.
3. Adjust the microswitch so that it is activated
by the highest point in the hydrostatic arm's
path when no driving pedal is pressed.
4. Adjust the microswitch so that it is definitely
activated by the hydrostatic arm, but allows
extra motion (it must not bottom out). Tip:
Hold a feeler gauge between the switch and
the arm when making the adjustment.
5. Replace the transmission cover.
63
English –