Husqvarna Rider 13C Workshop Manual page 44

Refitting hydrostatic transmission wire
1
Screw the front ball joint onto the new transmis-
sion wire and tighten the lock nut.
2
Run the wire through the mower so that it follows
the same route as the old wire.
42
– English
3
Press the wire casing in the front holder in the
middle bracket.
4
Screw tight the hydrostatic transmission wire's
clamp. Press the linkage in its holder and fit the
lock spring.
5
Screw tight the linkage on the lower part of the
transmission wire. Screw 10-12 turns so that the
linkage has the correct length.
Reparation instructions