Table of Contents
Advertisement
Installing / removing and connecting analyzer and option modules
7.11 Installing option modules
Preparing for installation
①
②
③
Figure 7-15
1. Isolate the device from power.
2. Loosen the six screws and open the door.
3. Loosen the three screws
4. Loosen the screw
bottom of the housing.
5. Remove the cable gland plate including the "Standard" terminal block
86
Screw shield plate
Screw, cable gland plate
Shielding plate signal lines
Removing the cable gland plate
①
②
on the inside of the right side panel and the eleven hex nuts
④
⑤
⑥
⑦
④
⑤
,
and
and remove the shield plate for signal cables
Operating Instructions, 07/2023, A5E31930403-AB
Screw shield plate
"Standard" terminal block on the cable
gland plate
Hexagon nuts (11 units)
⑥
.
Wall-mounted device
③
.
⑦
at the
Advertisement
Table of Contents
