Electrical Connections With Conduits - Siemens 7MB3000 Series Operating Instructions Manual

Connecting the device
8.2 Electrical connections
The adapters need to be fastened with 35 Nm in case they get loosed during installation.
8.2.4.2

Electrical connections with conduits

Electrical connections
①
②
Procedure
1. Undo the six screws
2. Remove the shielding plate
3. Strip the end of signal cable to a length of approx. 1 cm.
4. Remove the blind plug.
5. Insert the signal and power cable
6. Properly install a conduit connection. Thread Dimension NPT1. In case purging is used, make
sure that the conduit is gas tight sealed.
To see the terminal assignment go to chapter AUTOHOTSPOT
110
Door screws
Shielding plate
①
and open the door of the wall-mounted device.
②
on the right-side panel. To do this loosen the screws.
Operating Instructions, 07/2023, A5E31930403-AB
Wall-mounted device