Siemens 7MB3000 Series Operating Instructions Manual page 87

Performing installation
①
②
Figure 7-16
1. Inserting the terminal block:
– Insert the "Options" terminal block
– Tighten the 4 screws with a torque of 2.0 Nm.
2. Connect both terminal blocks with the existing connecting cable
3. Install the cable gland plate including both terminal blocks
with a torque of 0.8 Nm.
4. Tighten the screw for the cable gland plate again with a torque of 2.0 Nm.
Note
You use the same procedure for the conduit connections as for the cable gland plate.
Wall-mounted device
Operating Instructions, 07/2023, A5E31930403-AB
Installing / removing and connecting analyzer and option modules
"Options" terminal block
"Standard" terminal block
Inserting and connecting terminal blocks
②
block .
7.11 Installing option modules
③
Connecting cable terminal blocks
①
above the factory-installed "Standard" terminal
①
③
.
②
and with eleven hex nuts
87