12-4. Ethernet Interface Model
■ DIP-SW 1
Switch
-
Emulation
STAR line mode
-
ESC/POS mode
-
Reserved
-
Sensor adjustment
-
Reset using the INIT signal (pin #31)
Handshaking conditions
-
(conditions for BUSY)
1-7
ASB function*
STAR line mode
-
ESC/POS mode
-
Low peak current mode
-0
Installed cutter type
* ASB function:
Automatically sends a status signal to the host whenever the printer status changes (cover open, paper out, error, etc.).
For details, see the separate command specifications (Star Line mode, Star Page mode, and ESC/POS mode).
*2 NSB function:
Automatically sends a status signal whenever the printer switches to reverse transfer mode.
For details, see the separate command specifications (Star Line mode and Star Page mode).
■ DIP-SW 2
Switch
- to -
By factory default, all settings are set to ON.
DIP-SW 1
Function
Reserved
Resolution correction 0 dpi
NSB function*2
Reserved
Function
–
DIP-SW 2
ON
STAR line mode
Always ON
Always ON
Invalid
Valid
Receive buffer full or
offline
Invalid
Invalid
Always ON
Invalid
Partial cut
ON
Always ON
- -
OFF
ESC/POS mode
0 dpi
Valid
Invalid
Receive buffer full
Valid
Valid
Valid
Full cut
OFF