Dip Switch Settings - Star Micronics FVP-10U Hardware Manual

12. DIP Switch Settings

Two DIP switches are provided at the bottom of the printer, and you can set them according to the tables that start on the next
page.
To change the settings, follow the instructions given below.
(1) Check that the printer is turned off.
(2) Unfasten the screw holding the DIP switch cover at the bottom of the printer, and remove the cover.
DIP switch cover
OFF
ON
1 2 3 4 5 6 7 8 9 10 1 2 3 4
DIP-SW 1 DIP-SW 2
(3) Using a pointed object, set the DIP switches.
(4) Attach the DIP switch cover, and fasten it with screws.
Note: The new settings take effect when you turn on the printer.
- 0 -