Table of Contents
Advertisement
Installing/Removing
Wool Bonnet
The Model T33306 is supplied with a wool
bonnet for polishing operations.
To install/remove wool bonnet:
1. DISCONNECT
TOOL!
2. Place tool on tool rest with backing
pad upright (see Figure 14).
Note: If D-handle is installed, bonnet
can be installed with tool on its side.
3. Cover backing pad with bonnet
(see Figure 14).
Figure 14. Tool placed on tool rest and
bonnet placed loosely on backing pad.
Model T33306 (Mfd. Since 11/22)
BATTERY
FROM
Tool Rest
4. Securely tighten and tie bonnet
laces, and tuck laces into bonnet.
(see Figure 15).
Figure 15. Bonnet with laces tied and
tucked in.
5. Test that bonnet is securely fitted
by installing battery, then lifting and
starting tool. If bonnet appears loose
or becomes detached, stop tool and
re-install bonnet.
6. To remove bonnet, disconnect battery
from tool, then untuck and untie laces
and remove bonnet.
Bonnet,
Tied on
Backing
Pad
Laces
Tucked
In
-17
-
Advertisement
Table of Contents
