Grizzly T33306 Owner's Manual page 12

Charging/Installing
Battery
The Model T33306 is compatible with
Grizzly PRO 20V Lithium-Ion batteries and
chargers (see Accessories on Page 20).
Removing/Charging Battery
1. Press battery lock (see Figure 5) and
remove battery from sander.
Battery
Lock
Figure 5. Location of battery lock.
2. Plug charger into 120V outlet.
3. Slide battery into charger until battery
clicks in place (see Figure 6). Red light
will illuminate while battery is charging.
When green light illuminates, battery is
fully charged.
Note: Fully charge battery before first
use.
Battery
Figure 6. Battery charging in Model
T30302 Fast Charger (not included).
-10
-
Installing Battery in Router
1. Press battery lock (see Figure 7) and
Battery
2. Insert battery by aligning sander base
Figure 8. Battery installed in sander.
Charger
remove battery from charger.
Figure 7. Removal of battery.
with groove in battery and pushing in
direction of arrow until battery pack is
secured in tool (see Figure 8).
Model T33306 (Mfd. Since 11/22)
Battery
Lock