Table of Contents
Advertisement
Workpiece Inspection
Some workpieces are not safe to sand or
may require modification before they are
safe to sand. Before sanding, inspect all
workpieces for the following:
•
Material Type: This tool is intended
for sanding painted or unpainted
metal, fiberglass, wood, and com-
posite surfaces.
Foreign Objects: Fasteners, rivets,
•
clips, and other foreign objects are
often found in and around metal,
fiberglass, wood, and composite sur-
faces. While sanding, these objects
can become dislodged and hit the
operator, cause kickback, or cause
disc to fly apart, which could injure
operator, injure bystanders, or dam-
age workpiece surface. Always visu-
ally inspect your workpiece for these
items. If they cannot be removed, DO
NOT sand.
-14
-
Attaching/Removing
Sanding Discs
The Model T33306 is supplied with sand-
ing discs for use with the hook & loop
backing pad.
To attach/remove sanding disc:
1. DISCONNECT
TOOL!
2. Place tool on tool rest with backing
pad upright (see Figure 11).
Note: If D-handle is installed, disc can
be installed with tool on its side.
Tool
Rest
Figure 11. Tool placed on tool rest.
Only use 7" sanding discs that
are compatible with hook & loop
fasteners.
Model T33306 (Mfd. Since 11/22)
BATTERY
FROM
Advertisement
Table of Contents
