Grizzly T33306 Owner's Manual page 13

Assembly
Assembling the Model T33306 consists
of installing the D-handle on the sander
body. The D-handle is reversible and can
be installed on either side of the tool.
To assemble tool:
1. Attach D-handle to tool with (2)
M8-1.25 x 25 cap screws and (2) 8mm
flat washers (see Figure 9).
Mounting
Hole
(1 of 2)
Figure 9. D-handle installed on T33306.
Model T33306 (Mfd. Since 11/22)
Once assembly is complete, test run the
tool to ensure it is properly connected to
power and safety components are working
properly.
If you find an unusual problem during the
test run, immediately stop the tool, discon-
nect it from power, and fix the problem
BEFORE operating the tool again. The
Troubleshooting table in the SERVICE
section of this manual can help.
The test run consists of verifying the fol-
lowing: 1) The motor powers up and runs
correctly, and 2) Start/Stop switch safety
feature functions correctly.
D-Handle
DO NOT start tool until all preceding
setup instructions have been per-
formed. Operating an improperly set
up tool may result in malfunction or
unexpected results that can lead to
serious injury, death, or tool/prop-
erty damage.
Serious injury or death can result
from using tool BEFORE under-
standing its controls and related
safety information. DO NOT operate,
or allow others to operate, tool until
information is understood.
Test Run
-11
-