Grizzly T33306 Owner's Manual page 14

DO NOT start tool unless you have
both hands on tool. Torque from
motor can cause tool to twist. This
can lead to serious injury and tool/
property damage.
Before installing battery cartridge
into tool, always check to see that
Start/Stop switch actuates properly
and returns to STOP position when
released.
To test run tool:
1. Clear all setup tools away from tool.
2. Install battery in tool (see Charging/
Installing Battery on Page 10).
3. Pick up tool with one hand on handle
and other hand on D-handle (see
Figure 10), keeping tool away from
any surfaces or objects.
Figure 10. Sander handle locations.
-12
-
Handle
D-Handle
4. Press bottom of Start/Stop switch,
push switch forward, and lower
front of switch into locking tray
(see Page 6). Tool should run without
unusual problems or noises.
5. Press speed selector button to cycle
through RPM settings. Tool should
continue to run without unusual prob-
lems or noises.
6. Press and release bottom of Start/
Stop switch. Switch should automati-
cally return to Stop position, and tool
will stop.
— If tool does stop, Start/Stop switch is
working correctly.
— If tool does not stop, immedi-
ately disconnect battery. Contact
Technical Support before using tool.
7. Try to start motor by pushing Start/
Stop switch forward without applying
pressure on bottom of switch.
— If tool does not start, safety feature
of switch lockout is working cor-
rectly. Congratulations! Test run is
complete.
— If tool does start, immediately dis-
connect battery. Contact Technical
Support before using tool.
Model T33306 (Mfd. Since 11/22)