Position Send - Standard Horizon INTREPID + GX1270S Owner's Manual

6. After a DSC position request is transmitted, the transceiver remains
on channel 70 until position data is received.
POS REQUEST
BOB
.
35 55.000'N
.
138 28.000'W
NO REPLY
BOB
>SEND
EXIT
POS REQUEST
BOB
NO POSITION
DATA
10. When the transceiver receives the requested position, the
transceiver outputs a NMEA DSC sentence which may be used by a
Standard Horizon GPS chart plotter to show the vessels position.

6.10 POSITION SEND

The position send mode may be used to send your position to another radio
with this feature. Your vessel must have an operating GPS receiver
connected to the INTREPID+ to send the position and must not have its
transceiver set to deny position send.
JUN15 7:00P
15KT 160T
.
35 88.000'N
.
138 20.000'W
>INDIVIDUAL
GROUP
ALL SHIPS
TELEPHONE
STANDBY
CALL WAIT
POS REQUEST
>POS SEND
>TOM
MIKE
BOB
DICK
GX1270S
7. The transceiver received position data from a
vessel.
A
8. If the transceiver does not receive a reply, the
LCD will display ">SEND" to prompt the user to
send the call again or exit the mode.
A
9. If the transceiver received no position data, the
LCD will show "NO POSITION DATA".
A
When other vessel receives your position, the
transceiver outputs a NMEA DSC sentence
which may be used by a Standard Horizon GPS
A
chart plotter to show your position.
1. Select a traffic channel, then press the CALL/
SET key. Then the DSC CALLING menu will
appear in the display.
A
2. Press the UP or DOWN key to select the POS
SEND.
A
3. Press the CALL/SET key to select the Position
send directory. This directory uses the
INDIVIDUAL Directory information.
A
Owner's Manual page 30