Voice Scrambler; Operation With Voice Scrambler; Resetting The Transceiver'smicroprocessor - Standard Horizon INTREPID + GX1270S Owner's Manual

5.11 VOICE SCRAMBLER

If privacy of communications is desired, a CVS2500 voice scrambler (VS)
can be installed in the transceiver. Contact your Dealer to have a CVS2500
installed. Refer to the section 7.6 of DSC/RADIO SET UP mode to program
the voice scrambler.

5.11.1 Operation with voice scrambler

1. Turn on the transceiver.
HI USA
VS 3
HI USA
HI USA
VS OFF
3. Monitor the channel before transmitting.
4. Transmit the voice message. The signal sent will be scrambled.
5.12 RESETTING THE TRANSCEIVER'S MICROPROCESSOR
Resetting the microprocessor restores the initial, factory supplied
conditions in the transceiver. These are called the default conditions.
To reset the microprocessor, first turn the transceiver off. Then while
pressing the WX and SCAN keys, turn the transceiver on. The default
conditions are:
• No channels in SCAN memory.
• Channel 16 will be selected when the transceiver is turned on.
• WX channel 01 will be recalled when the WX key is pressed.
• Key beep will be on.
Resetting the microprocessor will not erase DSC MMSI and Directory
Call Waiting information.
GX1270S
2. Select a channel that was programmed for
scrambler mode. (Example: the voice scrambler
A
code is set 3.)
If a channel is not set for the voice scrambler,
the display will as shown in the illustration on the
left.
A
If a voice scrambler is canceled temporarily in
the SETUP menu, the display will be as shown
in the illustration on the left.
A
NOTE
Owner's Manual page 18