4. FISH FINDER SETUP MENU
1. From the Full Fish Finder page, press [MENU] to show the Fish Finder Setup menu.
2. From the Chart page, to access this menu:
a. Press [MENU]. Move the ShuttlePoint knob to SETUP and press [ENTER].
b. Move the ShuttlePoint knob to FISH FINDER SETUP and press [ENTER].
The following paragraphs describe the Fish Finder Setup menu sub-options.
4.0
PRESETS
Allows selection of the following preset modes: FISH, CRUISE. The default values are:
Fish
: Gain mode = Auto, Range mode = Auto Range, Gain Offset = 0%, Shift = 0, STC = Short, Noise
Level = 2, Scrolling Speed = 10, Fish Symbols = Echo, A-Scope = On, Surface Declutter = 0.
Cruise
: Gain mode = Auto, Range mode = Auto Range, Gain Offset = 10%, Shift = 0, STC = Short, Noise
Level = 4, Scrolling Speed = 10, Fish Symbols = Echo, A-Scope = On, Surface Declutter = 4.
For Gain and Gain Offset settings please see the Sensitivity menu (Par. 4.4).
For Range and Shift settings see the Range menu (see Par. 4.3).
4.1
PAGE SELECTION
The Page Selection menu allows you to adjust the Fish Finder display page to your
preference, sizing the Chart and Fish Finder page (see also Par. 3.1.0a).
FF520
Figure 4 - Fish Finder Setup menu
NOTE
Page 25