Electrical Information; Ventilation Requirements - Winston Industries cvap PS2198 Owner's Manual

electrical
The appliance is shipped from the factory
with a 84" (213cm) minimum power cord and
plug. Refer to the table below to determine
the correct electrical outlet. It may be
Model Volts Hertz
HBK5D1 120 60
INTERNATIONAL 230 50

ventilation requirements

.
Ventilation clearances
the appliance will need sufficient space for air
circulation. Allow at least 2" (51mm)
clearance on all sides, particularly around
ventilation holes. Care should be taken to
prevent placing the appliance close to
anything combustible. It must be installed with
its supplied feet or legs. Counter top
appliances supplied without feet or legs may
be placed directly upon a counter top of non-
combustible material. In this situation, the
appliance may have to be sealed to the
counter top with a food-grade silicone sealant
(check local health codes). Appliances may
be stacked upon each other using only a
Winston supplied stacking kit and following
the instructions enclosed with the kit. Your
warranty may be void if you do not adhere to
these ventilation requirements.
hold & serve drawer
PH Amps Watts
1 13.1 1572
1 7.5 1717
- To operate properly,
www.winstonind.com • 800-234-5286
necessary for a licensed electrician to install
the correct outlet or wiring. Winston does not
recommend wiring the appliance direct.
Below is electrical information for various
models of Winston's CVap
drawers.
Circuit
Amp
US 15 / CAN 20
N/A
High Temperature and Grease Hazard
Can cause property damage.
Avoid placing appliance near high heat or in grease
laden atmosphere.
Do not place appliance in an area where
ambient temperature (air temperature around
the appliance) exceeds 100°F (38˚C). A heat
shield may be required to prevent excessive
heat exposure and grease laden vapors from
affecting the appliance if adjacent to heat,
vapor, or grease generating devices (such as
grills, steamers, ovens, etc.). Excess heat
and grease inside the appliance cavities may
cause electrical components to fail.
Vent hood - Generally this appliance does
not need to be installed under a mechanical
ventilation system (vent hood). Check local
health and fire codes for requirements
specific to your location.
hold & serve
®
Plug
Type
US 5-15P/CAN 5-20P
N/A
5