Table of Contents
Advertisement
Be sure to disconnect the power cable from the power source before performing
any work on your mainboard, i. e. installing a CPU, memory module, changing
a jumper setting, etc. Not doing so may result in electrical shock!
2-1 Introduction to Jumpers
Putting jumper caps on anything that is not a jumper may result in damaging
your mainboard. Please refer to Section 1-3, Mainboard Layout, for the location
of jumpers on your mainboard.
Chapter 2
Hardware Setup
Figure 2-1
Hardware Setup
7
Advertisement
Table of Contents
Need help?
Do you have a question about the 6VJD and is the answer not in the manual?
Questions and answers