Installation Type - Elba EWF-N1287D(GR) Owner's Manual

3.4 CONNECTION OF THE WATER SUPPLY HOSE
Connect the other end of the water supply hose to the inlet water valve at the back of the washer.
Screw the hose clockwise tightly.

INSTALLATION TYPE 1

If the water tap is a screw type, assembly a water supply hose that fit to the tap
as shown.
INSTALLTION TYPE 2
1. Remove the adaptor from the water supply hose.
2. First, using a "+" type screw driver to loosen the four screws on the adaptor. Next, take
the adaptor and turn part (b) clockwise to leave a gap about 5mm between them.
5