Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Elba EW 6080 DGT
Summary of Contents for Elba EW 6080 DGT
- Page 1 EW 6080 DGT Washing Machine...
-
Page 2: Warnings General Safety
1 Warnings Safety instructions • This appliance must be connected to General Safety an earthed outlet protected by a fuse of • Never place your machine on a carpet suitable capacity. covered floor. Otherwise, lack of airflow • The supply and draining hoses must from below of your machine may cause always be securely fastened and remain in electrical parts to overheat. This may cause an undamaged state. problems with your washing machine. • Fit the draining hose to a washbasin or • If the power cable or mains plug is bathtub securely before starting up your damaged you must call Authorized Service machine. There may be a risk of being for repair. scalded due to high washing temperatures! • Fit the drain hose into the discharge • Never open the loading door or remove the housing securely to prevent any water filter while there is still water in the drum. leakage and to allow machine to take in • Unplug the machine when it is not in use. and discharge water as required. It is very • Never wash down the appliance with a important that the water intake and drain water hose! There is the risk of electric hoses are not folded, squeezed, or broken... -
Page 3: Installation Removing Packaging Reinforcement
2 Installation the machine. Removing packaging reinforcement Tilt the machine to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon. Opening the transportation locks Transportation safety bolts must be • If you are going to use your double water- removed before operating the washing inlet machine as a single (cold) water-inlet machine! Otherwise, the machine will be unit, you must install the stopper*, supplied damaged! with your machine to the hot water valve. 1. Loosen all the bolts with a spanner until • If you want to use both water inlets of the they rotate freely (“C”) product, you can connect the hot water 2. Remove transportation safety bolts by hose after removing the stopper and turning them gently. gasket group from the hot water valve. 3. Fit the covers (supplied in the bag with the * Applies for the products supplied with a blind Operation Manual) into the holes on the stopper group. rear panel. (“P”) • Models with a single water inlet should not be connected to the hot water tap. -
Page 4: Electrical Connection
Electrical connection Detergents and softeners Connect the machine to an earthed outlet Detergent Drawer protected by a fuse of suitable capacity. The detergent drawer is composed of three compartments: Important: • Connection should comply with national The detergent dispenser may be in two regulations. different types according to the model of your • The voltage and the allowed fuse machine. protection are specified in the section – (I) for prewash “Technical Specifications”. – (II) for main wash • The specified voltage must be equal to - (III) siphon your mains voltage. – ( ) for softener • Connection via extension cords or multi- plugs should not be made. A damaged power cable must be replaced by a qualified electrician. The appliance must not be operated unless it is repaired! There is the risk of electric shock! 3 Initial preparations for washing Detergent, softener and other cleaning Preparing clothes for washing... -
Page 5: Selecting A Program And Operating Your Machine
4 Selecting a Program and Operating Your Machine Control panel 1 - Spin Speed Adjustment Button 7 - Child-proof Lock Indicator* 2 - Time Delaying Button 8 - Program Follow-up Indicators 3 - Auxiliary Function Keys 9 - On/Off Button 4 - Start/Pause/Cancel Button 5 - Program Selection Knob * According to your machine’s model 6 - Display Turning the machine on •Cottons You can wash your durable clothes with this Plug in your machine. Turn the tap on... -
Page 6: Additional Programs
Additional programs If you only want to drain the water without spinning your laundry, select “Spin and Pump” For special cases, there are also extra program, and then select no spin function programs available: with spin speed selection button. Press “Start/ • Delicates Pause/Cancel” button. You can wash your delicate clothes on this You should use a lower spin speed for program. It has more sensitive washing delicate laundries. movements and does not make intermediate spinning compared to “Synthetic” program. Spin Speed selection • Daily You can use this program to wash cottons Whenever a new program is selected, the and synthetics together. There is no need to maximum spin speed of the selected program sort them. is displayed on the spin speed indicator. • Eco Synthetics To decrease the spin speed, press the “Spin” This program is suitable for clothes that button. Spin speed decreases gradually. Then, are normally worn for a short time such as rinse hold and no spin options are shown sportswear. It is used to quickly wash a small respectively. amount of cotton/synthetic blended clothes. Rinse hold is shown with “ ” and no spin is •... -
Page 7: Program And Consumption Table
Program and consumption table Programme • • • • • • Cottons 2.18 • • • • • • Cottons 60** 1.14 • • • • • • Cottons 0.66 • Active 0.87 • • • Intensive 1.29 • • •... -
Page 8: Auxiliary Functions
Auxiliary functions from the values in the consumption table subject to the changes in the water pressure, Auxiliary Function Selection Buttons water hardness and temperature, ambient Select the required auxiliary functions before temperature, type and amount of laundry, starting the program. auxiliary functions selected, and changes in Some combinations cannot be selected the supply voltage. together. (Ex.: Pre-wash and Quick Wash. Warning signal on the selected auxiliary Time delay function will light up. With the “Time delay” function you can delay the program start up to 24 hours. Time delay Auxiliary function selection can be set with steps of one hour for the first If an auxiliary function that should not be three hours and with steps of three hours for selected together with a previously selected the remainder (1, 2, 3, 6, 9, …24). function is chosen, the first selected function will be cancelled and the last auxiliary function 1. Press “Time Delay” button to adjust the selection will remain active. desired time. (Ex.: If you want to select pre-wash first and 2. Press “Start/Pause/Cancel” button. The then quick wash, pre-wash will be cancelled time delay will start to count down. and quick wash will remain active. More laundry may be loaded during the Auxiliary function that is not compatible time delay period. -
Page 9: Childproof Lock
automatic spin correction system has been 5 Maintenance and cleaning activated due to an excessive unbalanced Detergent Drawer distribution of laundry in the machine. Remove any powder residue buildup in the drawer. To do this; Changing the selections after the 1. Press the dotted point on the siphon in the program has started softener compartment and pull towards Turning the program knob while the program you until the compartment is removed from is in a normal flow will not change the the machine. program. Switching the machine to standby mode Press “Start/Pause/Cancel” button momentarily to switch your machine to the standby mode. Auxiliary functions can be cancelled or selected in accordance with the step the program is at. The door can be If more than a normal amount of water opened if the water level is suitable. Laundry and softener mixture starts to gather in the may be added / taken out by opening the softener compartment, the siphon must be... -
Page 10: Cleaning The Pump Filter
Draining any remaining water and by pulling out the plug at the end of the cleaning the pump filter hose. If the amount of water to be drained off is greater than the volume of the Your product is equipped with a filter system container, replace the plug, pour the water which ensures a cleaner water discharge that out, then resume the draining process. extends pump life by preventing solid items • After draining process is completed, such as buttons, coins and fabric fibers from replace the plug into the end of the hose clogging the pump propeller during discharge and fit the hose back into its place. of the washing water. If your product is not supplied with an • If your machine fails to drain the water, emergency drain hose, do the following as the pump filter may be clogged. You may shown in the figure below: have to clean it every 2 years or whenever it is plugged. Water must be drained off to clean the pump filter. In addition, water may have to be drained off completely in the following cases: • before transporting the machine (e.g. when moving house) • when there is the danger of frost In order to clean the dirty filter and discharge the water;... -
Page 11: Solution Suggestions For Problems
6 Solution suggestions for problems Problem Cause Explanation / Suggestion Machine may have switched Program cannot to self protection mode due to Reset your machine by pressing “Start/Pause/ be started or an infrastructure problem (such Cancel” button for 3 seconds. (see, Canceling a selected. as line voltage, water pressure, Program) etc.). There is water Be sure the seals of the water inlet hoses are coming from the There might be problems with securely fitted. bottom of the hoses or the pump filter. Tightly attach the drain hose to the tap. machine. Make sure that the pump filter is completely closed. Machine stopped Machine can stop temporarily It will resume operating when the voltage is back to shortly after the due to low voltage. the normal level. program started. The automatic spin correction system might have been activated due to the unbalanced distribution of It continuously the laundry in the drum. -
Page 12: Specifications
7 Specifications Models EW-6080DGT Maximum dry laundry capacity (kg) Height (cm) Width (cm) Depth (cm) Net Weight (kg) Electricity (V/Hz.) 220-240 V / 50hz Total Current (A) Total Power (W) 2000-2350 Spinning cycle (rpm max.) Specifications of this appliance may change without notice to improve the quality of the product. Figures in this manual are schematic and may not match your product exactly. Values stated on the machine labels or in the documentation accompanying it are obtained in laboratory in accordance with the relevant standards. Depending on operational and environmental conditions of the appliance, values may vary. This appliance’s packaging material is recyclable. Help recycle it and protect the environment by dropping it off in the municipal receptacles provided for this purpose. Your appliance also contains a great amount of recyclable material. It is marked with this label to indicate the used appliances that should not be mixed with other waste. This way, the appliance recycling organised by your manufacturer will be done under the best possible conditions, in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment. Contact your town hall or your retailer for the used appliance collection points closest to your home. We thank you doing your part to protect the environment. 3’’ Synthetics Woollens Delicate On/Off Start Coton Eco 40° Reset Hand synthetics Pause 3 sn.
Need help?
Do you have a question about the EW 6080 DGT and is the answer not in the manual?
Questions and answers