1 Important safety instructions • Follow the instructions on the textile tags and on the detergent package. This section contains safety instructions that will • The product must be unplugged during help protect from risk of personal injury or property installation, maintenance, cleaning and repairing damage. Failure to follow these instructions shall void procedures.
on top of each other reaches to approx. 180 hose (left) (max. 90 ºC) is for hot water inlet, blue kilograms. Place the product on a solid and flat hose (right) (max. 25 ºC) is for cold water inlet. floor that has sufficient load carrying capacity! • Do not place the product on the power cable. • Do not install the product at places where temperature may fall below 0ºC. • Place the product at least 1 cm away from the edges of other furniture. Removing packaging reinforcement Tilt the machine backwards to remove the packaging reinforcement.
Do not use any tools to loosen the lock nuts. Otherwise, they will get damaged. Electrical connection Connect the product to a grounded outlet protected • To prevent flowing of dirty water back into the by a fuse complying with the values in the "Technical machine and to allow for easy discharge, do specifications" table. Our company shall not be liable not immerse the hose end into the dirty water or for any damages that will arise when the product is drive it in the drain more than 15 cm. If it is too used without grounding in accordance with the local...
production. It is not harmful for the product. • Take out all substances in the pockets such as Disposing of packaging material coins, pens and paper clips, and turn pockets inside out and brush. Such objects may Packaging materials are dangerous to children. Keep damage the product or cause noise problem. packaging materials in a safe place away from reach •...
Using detergent and softener • Use lesser detergent for small amounts or lightly soiled clothes. Detergent Drawer • Use concentrated detergents in the The detergent drawer is composed of three recommended dosage. compartments: Using softeners - (1) for prewash Pour the softener into the softener compartment of - (2) for main wash the detergent drawer. – (3) for softener • Use the dosages recommended on the – (*) in addition, there is siphon piece in the softener package.
Page 7
laundry, close to the lower part of the drum in future washings. Use the tablet or gel detergent without selecting the prewash function. Using starch • Add liquid starch, powder starch or the dyestuff into the softener compartment as instructed on the package. • Do not use softener and starch together in a washing cycle. • Wipe the inside of the machine with a damp and clean cloth after using starch. Using bleaches •...
Tips for efficient washing Clothes Light colours and Delicates/ Colors Dark colors whites Woolens/Silks (Recommended (Recommended (Recommended (Recommended temperature range temperature range temperature range temperature range based based on soiling level: based on soiling based on soiling on soiling level: cold-40C) 40-90C) level: cold-40C) level: cold-30C) It may be necessary to pre-treat the...
4 Operating the product Control panel 1 - Programme Selection knob (Uppermost position 4 - Spin Speed adjustment button On/Off) 5 - Auxiliary Function buttons 2 - Programme Follow-up indicator 6 - Delayed Start button (in some models) 3 - Temperature Adjustment button 7 - Start / Pause button Preparing the machine Always select the lowest required temperature. Make sure that the hoses are connected tightly. Plug Higher temperature means higher power in your machine. Turn the tap on completely. Place consumption. the laundry in the machine. Add detergent and fabric For further programme details, see "Programme softener.
Additional programmes Temperature selection For special cases, additional programmes are Whenever a new programme is selected, the available in the machine. recommended temperature for the selected programme appears on the temperature indicator. Additional programmes may differ according to To decrease the temperature, press the Temperature the model of the machine.
Auxiliary function selection process if you want to drain the water without spinning your laundry. Programme will resume and Use the following auxiliary functions according to your complete after draining the water. daily needs. Select the desired auxiliary functions If you want to spin the laundry held in water, adjust before starting the programme. Furthermore, you the Spin Speed and press Start / Pause button. may also select or cancel auxiliary functions that The programme resumes.
Starting the programme To do this, the change you are going to make must be in a step after the running programme step. If the Press Start / Pause button to start the programme. change is not compatible, relevant lights will flash for Programme follow-up light showing the startup of the 3 times. programme will turn on. If the machine does not pass to the spinning If no programme is started or no key is pressed step, Rinse Hold function might be active or the...
Your machine will end the programme when you front section downwards to make sure that turn the Programme Selection knob; however, the locking tab engages. it does not drain the water inside. When you Cleaning the water intake filters select and start a new programme, the newly There is a filter at the end of each water intake selected programme will start depending on the valve at the rear of the machine and also at...
Page 15
and pull the piece out towards yourself. If the filter cap is one piece, pull the cap from both sides at the top to open. You can remove the filter cover by slightly pushing downwards with a thin plastic tipped tool, through the gap above the filter cover. Do not use metal tipped tools to remove the cover. Some of our products have emergency draining hose and some does not have.
7 Troubleshooting Programme cannot be started or selected. • Washing machine has switched to self protection mode due to a supply problem (line voltage, water pressure, etc.). >>> To cancel the programme, turn the Programme Selection knob to select another programme. Previous programme will be cancelled. (See "Canceling the programme") Water in the machine. • Some water might have remained in the product due to the quality control processes in the production. >>> This is not a failure; water is not harmful to the machine. Machine vibrates or makes noise. •...
Need help?
Do you have a question about the EWF 0861 A and is the answer not in the manual?
Questions and answers