Set Up Instructions - Craftsman 127.28876 Operator's Manual

SET UP iNSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
Wrecking bar
Claw hammer
Sockets: 1/2", 15/16
Wrenches: 18mm, 1/2", 9/16", 3/4", 15/16"
Tire pressure gauge
NOTE: All references below to the "right" or "left" are with respect to an operator at the controls.
1. UNCRATE UNIT
a) Discard packing materials, Loosen the caster wheel axle bolts and bumper bolts to remove the shipping
brackets.
Discard shipping brackets.
b) Re-install and tighten bumper bolts.
c) Tighten caster wheel axle bolts against caster axle spanner bushings to 80 ft/Ibs.
2. TIRE PRESSURE
a) Set tire pressures to 14 Ibs/in 2 (1.0 kg/cm2). Tires are overinflated for shipping.
3, TRACTION LEVERS
a) Tighten bolt A.
b) Sit on the machine. Levers C may be moved to
upper set of holes in bar B for a better operator
fit.
19