Space-Ray FUSION Series Installation & Operation Instructions page 25

US ONLY:
A gas connector certified for use on a tubular type infrared heater per the standard for Connectors for
Gas Appliances, ANSI Z21.24/CSA 6.10 is supplied for installation in US only. The gas connector is 36" long and
1/2" nominal ID, and must be installed as shown above, in one plane, and without sharp bends, kinks or twists.
CANADA ONLY:
A Type I hose connector should be used that is certified as being in compliance with the
Standard for Elastomeric Composite Hose and Hose Couplings for Conducting Propane and Natural Gas
(CAN/CGA 8.1) and is of length of 36+/- 6 in (90+/- 15 cm). The gas connector must be installed as shown above,
in one plane, and without sharp bends, kinks or twists.
US ONLY: Connector MUST be installed in "" configuration. Use only
the 36" long connector that was furnished with this heater.
-24-
Form 43343100
April 2022 A