Table of Contents
Advertisement
RC4080 ACU
2.1.2.2.2.3 LOCATION
The LOCATION mode allows the user to set the latitude, longitude, heading and pitch/roll of the antenna
for subsequent use in calculating pointing angles to satellites. The first screen that appears shows the
current mount position used in the RC4080. Also shown are the source that was used to acquire the
current position data. If any field was not already populated, *** would be shown.
L / L : 3 8 _ 5 7 N
A N T B E A R I N G : 1 8 1 . 6 C O M P A S S
P :
< 1 > L A T / L O N < 2 > H E A D I N G < 3 > T I L T < M O D E > M E N U
2.1.2.2.2.3.1 LAT/LON
When the user chooses to modify latitude and longitude, a screen appears showing three options for
updating the current lat/lon.
< 1 > E N T E R M A N U A L L O C A T I O N
< 3 > G E T L O C A T I O N F R O M G P S
<1>ENTER MANUAL LOCATION
L A T :
E N T E R L A T I T U D E < D E G .M I N >
The user is provided two fields to manually enter lat and lon. See 2.1.2.1.3 for instructions on how to
enter latitude and longitude.
<3>GET LOCATION FROM GPS
G P S : 3 8 _ 5 7 N
U T C : 1 4 : 2 0 : 4 8
When option 3 is selected, the RC4080 will pull in the lat/lon from the GPS. Once complete the controller
will automatically move back to the main LOCATION screen. Note that if movement is required to acquire
the GPS information, the following screen will be displayed so the user can confirm the movement.
< E N T E R > C O N F I R M M O V E
Chapter 5
9 4 _ 4 5 W
0 . 6 R :
0 . 5
A U T O
L O N :
9 4 _ 4 5 W
*
A N T E N N A M O V E M E N T R E Q U I R E D
*
T O D E T E R M I N E L O C A T I O N
G P S
P O S I T I O N
L A T / L O N
< M O D E > E X I T
L A T / L O N
< S C R > E X I T
L A T / L O N
< M O D E > E X I T
L A T / L O N
< M O D E > E X I T
32
Support
*
*
Advertisement
Table of Contents
